VanWiki FAQs
Find gear for your Sprinter, Transit or ProMaster. Start with your van, check how the part mounts, and use the planning tools to compare weight and dimensions before you buy.
Find parts for your van
What do I need to know about my van before I shop?
Start with the make, model year, wheelbase and roof height. Add the body length and drivetrain when the part depends on them. Note anything already installed where the new part goes, such as roof rails, a rear ladder or aftermarket interior trim. Use the VanWiki vehicle guides to see which details matter for your platform.
Are wheelbase and body length the same?
No. Wheelbase is the distance between the front and rear axles. Body length also includes the overhang past the axles. A standard and extended body can share a wheelbase, so check both when you’re buying a side step, roof rack or other part that spans the body.
Will a part fit if it’s listed for my van’s make and model?
Not necessarily. A listing for “Sprinter,” “Transit” or “ProMaster” narrows the search. Before you order, compare your exact year and configuration with the manufacturer’s fitment chart and install guide. A year range, roof height, mounting point or existing accessory can rule out a part that otherwise looks right.
How do I compare similar parts without starting over on every brand’s site?
Narrow the list to your van first. Compare the specs that change your choice: what the part weighs, how it mounts, what’s included and what it might block. Keep a missing spec marked unknown rather than treating it as a match. Browse the gear categories to get to the right set of parts.
Roof racks, solar & fans
Where can I compare roof racks for my van?
Use the Sprinter comparison, Transit comparison or ProMaster comparison to build a shortlist. Then check the maker’s instructions for the rack and mounting kit you’d actually order. Use the Roof Load Planner separately to total your setup’s weight and check whether there’s a confirmed limit for your van.
Do I need factory roof rails, or can I install a rack without drilling?
It depends on the rack and the van. A system may need factory rails, use existing mounting points, or require drilling. Check the install guide for your exact kit and find out whether rails, feet and hardware are included or sold separately. “No drill” for the rack doesn’t mean every accessory mounts without drilling. See the roof rack guide for the different mounting styles.
Should I buy crossbars or a full platform rack?
Start with what you’ll mount. Crossbars can be enough if their spacing and hardware match the load you plan to carry. A platform gives you more places to mount gear, but check its own weight and how much room it leaves around vents, solar panels and service points. Compare usable mounting space, not just the rack’s outside dimensions.
Can I fit solar panels, a roof fan and an awning on the same rack?
Sometimes. Sketch the roof with each item’s mounting footprint, then check the fan lid’s full opening, the solar panel brackets and the awning mount. A panel that clears a closed fan can still block the lid. Use the component makers’ drawings or install guides to confirm the spacing and leave room for wiring and service access.
Roof weight & vehicle height
Does the roof rack count toward my van’s roof-load limit?
Yes. Count the rack, mounting hardware and accessories, plus everything you carry on it. That may include panels, brackets, an awning, a box and what’s inside the box. The Roof Load Planner adds those weights and shows the source for the vehicle limit it uses.
What’s the difference between static and dynamic roof load?
Dynamic is the limit while driving. Static is the limit while parked, if the maker publishes one. A parked rating is not a driving rating, and a driving rating doesn’t tell you how much the setup can hold while parked. For a rooftop tent, check the weight carried while driving and confirm the parked limits with the van, rack and tent makers.
Which roof-load limit applies if my van and rack have different ratings?
You have to meet both limits. The van’s limit covers the rack and what’s on it. A rack maker may rate the load carried by the rack instead; check what its number includes. Also check any per-bar, per-mount or load-distribution rules. Don’t add ratings or take a higher rack rating as permission to exceed the van’s limit.
What if there’s no confirmed roof-load limit for my exact van?
Treat the capacity as unknown, not zero and not the number for a similar van. Use the planner to total the weights you know, then check the owner’s manual or body-builder guide for your exact configuration. If the planner labels a figure as a reference rather than a confirmed limit, verify it with the vehicle maker before relying on it.
How do I know whether my van will fit under a garage door after adding a rack?
Measure the finished van on level ground to its highest point in the configuration you drive, including anything taller than the rack itself. Compare that height with the lowest point on the full route into the garage, including the open door and any hardware. Leave a clearance margin and check the van’s actual path on any slope or transition. If clearance is close or uncertain, don’t drive through. Before install, ask the rack maker for the installed height increase on your exact van; a rack’s listed height alone may not tell you that.
Tires & wheels
What does a tire size like 245/75R16 mean?
245 is the nominal section width in millimeters. 75 means the sidewall height is nominally 75% of that width. R means radial construction, and 16 is the wheel diameter in inches. Read load and speed ratings separately; they aren’t specified by those four parts of the size.
How much ground clearance will larger tires add?
For a rough comparison, take half the increase in nominal tire diameter. Going from 245/75R16 to 265/70R17 adds about 0.57 inches in the Tire Size Calculator. That’s a size-based estimate, not a measurement of your loaded van. Actual tire dimensions and deflection can change the result.
Can the Tire Size Calculator tell me what will fit without rubbing?
No. It compares dimensions; it doesn’t check the van. Check the exact tire model’s published measurements and approved wheel widths, the wheel’s offset, and room at full steering lock and through suspension travel. Check the spare’s storage space, too. Clearance alone doesn’t make a tire and wheel safe for your van. Have a qualified installer verify load capacity, speed rating and inflation requirements against your vehicle’s requirements before using a size the vehicle maker doesn’t list.
Will a larger tire change what my speedometer shows?
If the speedometer stays calibrated for the old tires, a larger rolling circumference means the van travels farther per wheel revolution. You can be moving faster than the reading shows. Use the calculator for the estimated difference, not as confirmation that the speedometer has been recalibrated.
Exterior gear, screens & covers
Can I add a rear-door tire carrier and still open both doors?
Check the carrier’s install guide for the door side, hinge setup and allowed swing. Compare the installed carrier and tire against your ladder, bumper and hitch gear. Also check the handle, camera, plate and lights. A carrier can fit the van and still interfere with another accessory. See the rear-door systems guide.
Will an aftermarket bumper work with my parking sensors and tow setup?
Look for explicit support for the sensors, camera, hitch or towing hardware your van has. Check the install guide for brackets, relocations and any functions the maker says are not supported. Don’t assume a bumper that bolts up also preserves every factory feature. Start with bumpers and protection.
What should I check before choosing side steps or running boards?
Check the wheelbase, mounting points, which doors the step serves and where it sits relative to the ground. Underbody gear or existing brackets can occupy the same space. A lower step can make entry easier, but it may also reduce clearance at the side of the van. See steps and access.
How do I pick the right bug screen or window cover?
Match the exact opening, not just the van model. A sliding-door screen is not a rear-door screen, and window covers can depend on the glass shape, factory trim and how they attach. On a converted van, check whether cabinets or added trim cover the mounting edge. Start with bug screens or window covers and insulation.
Sources & corrections
What does “indexed” mean on VanWiki?
It means VanWiki has recorded a product in the catalog. It doesn’t mean WNDR Built stocks it, has tested it, or guarantees it fits every version of the van shown. Use the listed specs and source links to narrow your options, then confirm the details that matter for your build.
What if the listing and the manufacturer’s instructions disagree?
Check that the maker’s document matches the exact part, revision and vehicle. If the difference affects fit, load or installation, confirm it with the maker before ordering. How We Research explains what VanWiki checks and what gets marked unknown.
Can I suggest a missing product or send a correction?
Yes. Use the contact form and include the product name, the maker’s link and the specific detail to add or correct. For fitment, include the year, wheelbase, roof height or other configuration detail that changes the answer.
