
VANNON
VANNON Rear Bug Screen
Indexed listing. WNDR Built doesn't sell this product; the button opens vannon.com.
Rear-door ventilation with magnetic access
The VANNON Rear Bug Screen puts a mesh insect barrier across the rear cargo opening while allowing air through. Its magnetic center closure lets you pass into the garage area without unzipping the screen or removing it from the doorway.
The panel rolls up when it is not in use. That gives you a way to stow the screen as well as a separate center opening for passing through while it remains down.
Reinforced perimeter
A reinforced ripstop fabric perimeter surrounds the nylon mesh.
California sewing
Made in the USA and hand sewn in California.
Manufacturer-listed fitment & checks
Vehicle fitment
As listed by VANNON
Mercedes-Benz Sprinter vans, 2019 and newer; rear-door opening.
Screen tension and clip removal
Keep the magnetic closure fastened during installation and leave slack for the gasket to tension the fabric. If the screen is too tight, the center magnets will not reconnect automatically. Removing clips can damage the fabric or gasket.
Installer guidance
VANNON recommends installation by a certified mechanic; otherwise, installers must read, understand and follow the instructions and warnings before installation.
Specs, parts & installation
Fabric and construction
| Screen | Nylon mesh |
|---|---|
| Perimeter | Reinforced ripstop fabric |
| Closure | Magnetic center closure |
| Origin | Made in the USA; hand sewn in California |
What’s in the box
Screen
1 screen.
Mounting hardware
20 fastener clips, as listed in the shared Rear Bug Screen/Storm Wall guide.
Installation at a glance
Install with a helper; the guide lists a rubber mallet.
The screen clips behind the factory rear-door gasket. Peel back the top and sides, leaving the bottom edge attached, then reseat the gasket after clipping the screen in place.
Installation sequence from the shared guide
- Peel back the top and sides of the door gasket, leaving the bottom edge attached, and place the loosened gasket inside the van.
- Center the screen on the upper door latches; a strong magnet may hold it temporarily while you adjust it.
- Set the bottom edge flush with the threshold, keeping the centerline straight and leaving slack in the fabric.
- Place the first 5 clips along the top edge, then clips at the top corners. Work down each side with a clip every 12-16 inches.
- Start at a bottom corner and reseat the gasket with light taps from a rubber mallet. Check the full frame; if you remove and reseat the gasket again, ensure no clips come out with it.
- Test that the magnetic closure reconnects after passing through.
Tools listed in the guide
- Rubber mallet.
- Strong magnets are optional for holding the screen during adjustment.
Lead Time
Shipping is calculated at checkout; select continental U.S. ground orders over $300 qualify for free shipping.
Read VANNON lead time policy on WNDR BuiltWarranty
Read VANNON warranty policy on WNDR BuiltReturns
VANNON must receive eligible returns within 30 days of purchase; custom or installed products are excluded, and a 20% restocking fee plus return shipping applies.
Read VANNON returns policy on WNDR BuiltWhat are people saying?
Find owner feedback, discussions, and installation videos for this product.
Searches use the manufacturer and product name and open in a new tab. Results may include similar products.
WNDR Built Community
Our community blog is coming in the future.
Community · Coming soon