
VANNON
VANNON Slider Bug Screen
Indexed listing. WNDR Built doesn't sell this product; the button opens vannon.com.
A mesh barrier for the sliding doorway
The VANNON Slider Bug Screen covers the sliding doorway with mesh, letting air circulate while keeping insects outside. A magnetic center opening provides a way through the panel without using hook-and-loop strips at the center closure.
The mesh panel can roll up or be fully removed when it is not needed. That gives you a choice between leaving the screen in use across the doorway, rolling it up or taking the mesh panel off.
Ripstop fabric
VANNON specifies high-strength mesh and waterproof ripstop fabric.
Zipper construction
The screen uses heavy-duty zippers.
California sewing
Made in the USA and hand sewn in California.
Manufacturer-listed fitment & checks
Vehicle fitment
As listed by VANNON
Mercedes-Benz Sprinter vans, 2007 - 2024 models; passenger-side sliding door.
Alignment and tension
The guide calls for a 1.5” overlap on all sides and a bottom edge flush with the entry step. Keep the magnetic closure fastened during installation and leave slack for the gasket to tension the fabric; if too tight, the center magnets will not reconnect automatically.
Clip removal
Removing the clips can damage the fabric or gasket.
Installer guidance
VANNON recommends installation by a certified mechanic; otherwise, installers must read, understand and follow the instructions and warnings before installation.
Specs, parts & installation
Fabric and construction
| Materials | High-strength mesh and waterproof ripstop fabric |
|---|---|
| Closure | Magnetic center closure |
| Zippers | Heavy-duty zippers |
| Origin | Made in the USA; hand sewn in California |
What’s in the box
Screen
1 doorway screen.
Mounting hardware
17 upholstery clips with hooks, as listed in the Slider Bug Screen guide.
Installation at a glance
VANNON states installation takes under an hour; the guide calls for a second person.
The screen clips behind the factory door gasket. The guide lists a rubber mallet and blue tape, with strong magnets optional.
Installation sequence from the guide
- Peel back the top and sides of the gasket, leaving the bottom edge attached, and place the loosened gasket inside the van.
- With a second person, hold and align the screen using blue tape or a strong magnet for temporary support.
- Place the first 3 clips along the top edge, then clips at the top corners.
- Keep the centerline straight, working down the right side with a clip every 12-16 inches, then repeat on the opposite side.
- Reseat the gasket with light mallet taps from the bottom right corner up to the top corner. Repeat on the left, then reinstall the top section.
- Check the gasket is pressed down all the way around and test that the magnetic closure reconnects after passing through.
Tools listed in the guide
- Rubber mallet.
- Blue tape.
- Strong magnets are optional.
Lead Time
Shipping is calculated at checkout; select continental U.S. ground orders over $300 qualify for free shipping.
Read VANNON lead time policy on WNDR BuiltWarranty
Read VANNON warranty policy on WNDR BuiltReturns
VANNON must receive eligible returns within 30 days of purchase; custom or installed products are excluded, and a 20% restocking fee plus return shipping applies.
Read VANNON returns policy on WNDR BuiltWhat are people saying?
Find owner feedback, discussions, and installation videos for this product.
Searches use the manufacturer and product name and open in a new tab. Results may include similar products.
WNDR Built Community
Our community blog is coming in the future.
Community · Coming soon