
Aluminess
Rear Door Ladder - 2019-26 Sprinter
Indexed listing. WNDR Built doesn't sell this product; the button opens aluminess.com.
Rear-door roof access with an optional tire or box mount
This all-aluminum ladder provides access to roof cargo from the rear of a Sprinter. Its shaped top gives your foot a place to brace while climbing or securing gear, rather than using a curved top rung.
The ladder attaches through hinge brackets and an inner door bracket at the latch. The tire/box-mount configuration adds supports and offset folding steps so you can climb around the mounted gear; the mount can also be added later.
Foot clearance
Aluminess states the ladder sits an average of 4.5” off the van to provide room for stepping onto the rungs.
Backup sensors
Aluminess lists compatibility with backup sensors.
Manufacturer-listed fitment & checks
Vehicle fitment
As listed by Aluminess
- 2019-26 Mercedes Sprinter (maker title).
- 2019-23 Revel; 2019-23 Storyteller.
Choose your roof configuration
Match the configuration to your van’s roof height.
With Low Roof
- Low-roof configuration
With High Roof
- High-roof configuration
Choose the ladder or combo
Both roof configurations are offered in either style.
Without Tire/Box Mount
- Ladder without the tire/box mount; the mount can be added later.
With Tire/Box Mount
- Box or spare-tire mount and offset folding steps.
- Aluminess says all hardware needed to mount either a storage box or spare tire is included with the combo.
Weather-stripping must be cut
No drilling through the door is required, but the manual requires cutting the weather-stripping’s attachment channel around the inner driver-door bracket, not its hollow bulb.
Door opening and clearance
The included limiting strap prevents the doors from opening fully. The manual labels strap installation optional and requires checking clearance between the product, van body and lower hinge while opening and closing the doors.
Box and accessories excluded
The box and other accessories are not included.
Use and legal compliance
Aluminess states its products are designed for off-road vehicle use and may exceed factory-designed vehicle capabilities. Purchasers must determine suitability and review applicable vehicle laws before use.
Hinges
Compatible with 180 and 270 degree hinges; the hinges do not need to be swapped or removed from the door.
Companion mounts
Compatible with a RotopaX Mounting Kit. When the tire/box carrier is fitted, it must be used with an Aluminess rear-door ladder; this listing offers the Sprinter ladder with or without that mount.
Aftermarket vehicle conversions
Aluminess designs its products for factory-manufactured vehicles; some aftermarket conversions are incompatible.
Specs, parts & installation
Ladder construction
| Material | All-aluminum |
|---|---|
| Finish | Powder-coated textured black |
| Stand-off | Average of 4.5” off the van |
Maker-listed capacities
| Ladder dynamic capacity | Aluminess states: 100 lbs; ladder manual specifies maximum load of 100 lbs while traveling. |
|---|---|
| Ladder static capacity | Aluminess product page states: 300 lbs. |
| Tire/box carrier maximum | Carrier manual states: maximum load capacity 100 lbs on the box/tire rack once installed. |
Shipping dimensions
| Height | 8 IN. |
|---|---|
| Width | 76 IN. |
| Depth | 29 IN. |
| Weight | 33 LBS. |
What’s in the box
Ladder and mounting brackets
Ladder in the selected roof configuration; upper and lower driver-side hinge brackets, inner driver-door bracket, three M8 machined spacers and a rubber latch spacer.
Door protection and strap
Center, lower-hinge and upper-hinge protective tape; door-limiting strap, hard-stop strap bracket and clamp, and webbing anchor.
Ladder fasteners and supplies
M8 and 5/16 mounting bolts, washers and locknuts; 10-32 strap fasteners; anti-seize and blue medium-strength thread locker, as listed in the ladder manual.
With Tire/Box Mount only
Three preassembled folding step mounts; two tire/box supports; universal tire-mount bracket, wheel wedge and cover; mounting bolts, washers, nuts, four tamper-resistant bolts, tamper-resistant hex bit, key-chain bit holder and anti-seize.
Installation at a glance
Aluminess’s FAQ lists 2-3 hours; the manual requires two or more people. Existing mounts, accessories and skill level can affect time and difficulty.
Bolt-on installation uses factory mounting points. Apply anti-seize to stainless hardware and blue thread locker where the guide specifies.
Apply protective tape out of direct sunlight, above 60 ˚F, with clean hands. Install the latch and hinge brackets following the guide, keeping the upper hinge bolt installed while the lower one is removed.
Check latch alignment without closing the door while its bolts are loose. Set the center bracket gap to 0 to 1/8”; use the supplied 1/8” washers as shims if needed. Cut and refit the weather-stripping as described in Fitment.
Check all clearances, then recheck mounting hardware after the first 100 miles and periodically thereafter.
Tools listed for the ladder
- Standard/metric wrenches and sockets; standard Allen keys; Torx bit
- Tin snips or heavy-duty cutting pliers
- Isopropyl alcohol, liquid soap, spray bottle, clean rag and squeegee or plastic card
Optional tire/box carrier setup
- Apply anti-seize before assembly and fit the supports to the lower crossmember, equally spaced from the center post.
- Adjust the tire bracket vertically until its center aligns with the wheel hub, remove the tire and tighten the bracket hardware.
- Mount the tire and wheel wedge; the carrier guide lists the Sprinter preferred torque as 70-inch pounds.
- If fitting a RotopaX mount to the wheel wedge, use the security bolts before fitting the container. Do not use the wheel-wedge cover with that mount.
- Recheck carrier hardware after the first 100 miles and periodically thereafter.
Lead Time
Read Aluminess lead time policy on WNDR BuiltWarranty
Read Aluminess warranty policy on WNDR BuiltReturns
Read Aluminess returns policy on WNDR BuiltWhat are people saying?
Find owner feedback, discussions, and installation videos for this product.
Searches use the manufacturer and product name and open in a new tab. Results may include similar products.
WNDR Built Community
Our community blog is coming in the future.
Community · Coming soon