
The BugWall
RAM Promaster Side Sliding Door Insect Screen
Indexed listing. WNDR Built doesn't sell this product; the button opens thebugwall.com.
A sliding-door screen with a choice of entry position
The BugWall V2 screens the ProMaster sliding doorway with No-See-Um netting and marine canvas. Its magnetic or zippered opening provides a route in and out while the screen is in place.
You can place that opening in the center or offset it toward the front or rear to suit the way you pass your cabinetry. The offset positions let the screen open to its highest point near where your head passes through.
Marine zippers
Marine-grade side zippers let the screen roll up; built-in buckle straps hold the rolled flaps.
Removable screen
The V2 top zipper lets you remove the rolled-up screen when insect protection is not needed.
Weighted bottom
Added foam along the bottom increases its weight and helps the screen roll up.
Manufacturer-listed fitment & checks
Vehicle fitment
As listed by The BugWall
Fits RAM ProMaster · High Roof or Low Roof · sliding side door.
Choose the entry location
Choose the opening where you normally walk in and out; if cabinetry sends you toward the front, choose the front opening.
Center
- Opening in the center.
Opening closer to FRONT of Van
- Opening approx. 14" from the front edge of the door opening.
Opening closer to REAR of Van
- Opening approx. 14" from the rear edge of the door opening.
Choose the closure
The maker offers these opening types.
Magnet
- Magnetic closure for walking in and out.
Zipper
- A zippered opening instead of the magnetic closure.
Magnetic-screen tension
On Magnet versions, excessive side-to-side tension prevents the magnetic strip from operating correctly; do not install the screen too tight.
Fabric trimming required
Installation involves trimming excess screen material. On sliding doors, do not close the door before trimming: excess fabric could get caught.
Sliding-door clearance
Position the left zipper so it does not interfere with the left weather seal. Center the screen between the seal’s bump-out and the right doorway edge.
Travato installation kit
Travato owners must email The BugWall with their order number to receive the Travato installation kit with the screen.
Rear screens sold separately
The maker offers two rear-door screen options separately.
Specs, parts & installation
Screen construction
| Fabric | US-made marine canvas |
|---|---|
| Netting | No-See-Um bug netting |
| Zippers | Marine-grade zippers on both sides and across the top |
| Bottom edge | Added foam for weight and roll-up |
What’s in the box
Screen
Door screen with built-in buckle straps and foam along the bottom.
Installation supplies
Double-sided tape, retaining clips and a BugWall coozie, as stated in the maker’s installation guide.
Travato kit
For Travato owners who email the maker with their order number, the maker supplies a Travato installation kit with the screen.
Installation at a glance
Mount the screen around the doorway flange with double-sided tape and retaining clips, then reinstall the weather seal.
Follow the updated written instructions; older videos are a visual guide only, and any supplied supplemental instructions also apply. Pinch the weather seal closed before reinstalling it, then check that it is fully seated, especially at the corners.
If the weather seal is trapped behind another part, follow the trapped-seal guidance in the linked installation instructions.
Use the side-screen guideline at the upper flange to set the bottom just past the step/floor; do not set it lower. Raise it if you want it at or just above the floor. Where a guideline is absent, initially hang the screen about an inch too long before wrapping and clipping.
On ProMaster sliding doors, remove the forward lower plastic trim if possible and leave extra fabric slack for reinstallation. Alternatively, loosen its 2 screws, tuck the screen behind the plastic and retighten. For Travato, Sequence or other trapped-seal installations, use the maker’s trapped-seal video; bars and instructions are included if the maker was told about the Travato or Sequence.
Installation sequence
- Mark the weather seal’s original position before removing it; clean the doorway flange with alcohol or water.
- Apply double-sided tape across the top and around both upper corners, folded half onto each side of the flange.
- Check the screen’s side-to-side position and length before fitting clips; leave fabric room behind the corners so the weather seal can seat fully.
- For top clips, fit a few thick clips first, check the length, then add clips about every 6-8" across the top.
- Wrap the fabric around the side flanges and choose retaining clips to suit the metal thickness; relief cuts can help the fabric follow the left-side bump-out. Keep the zippers straight.
- Once satisfied with the placement, trim the excess fabric; the maker recommends scissors.
- Pinch the seal closed, reinstall it in its marked position and use a mallet to ensure it is seated around the opening.
Tools and supplies mentioned by the maker
- Marker; alcohol or water for cleaning.
- Small hammer or mallet for seating clips and the weather seal.
- Scissors for trimming; the maker also mentions a razor but recommends scissors.
Lead Time
Lead times vary; contact the maker. Product banner: about 1 week to shipment for new orders; international taxes, fees, duties and tariffs are the buyer’s responsibility.
This product
The maker’s product-page banner currently estimates 1 week until shipment from its shop for new orders.
Warranty
Read The BugWall warranty policy on WNDR BuiltReturns
Returns within 30 days; later returns incur a 25% fee and are not accepted after 90 days.
Read The BugWall returns policy on WNDR BuiltWhat are people saying?
Find owner feedback, discussions, and installation videos for this product.
Owner reports
Quotes from owners and installers, with links to where they were posted. These are owner reports, not manufacturer-confirmed information, and may describe a different van or year than yours. Verify before you buy.
i installed Bug wall and it doesn’t interfere with my lower bench that extends into the door.
View originalbefore it snaps right back together again (sometimes with a bit of fussing to get it perfectly sealed).
View originalWhen you’re just lounging in the van, it lets in more of a breeze than any windows possibly could.
View originalSearches use the manufacturer and product name and open in a new tab. Results may include similar products.
WNDR Built Community
Our community blog is coming in the future.
Community · Coming soon