
Dark Star Offroad
Mercedes Sprinter Side Steps
Indexed listing. WNDR Built doesn't sell this product; the button opens darkstaroffroad.com.
Running boards for entry and loading
These running-board steps provide a platform at the driver door and along the passenger side of a Mercedes Sprinter, for getting into the van or loading gear.
Holes in the step surface shed water and dirt. Dark Star Offroad describes the surface as comfortable for bare feet and dogs, combining that perforated design with an aluminum platform.
Black powder-coat finish
The aluminum steps have a black powder-coat finish.
Stainless steel fasteners
The installation guide lists stainless steel step bolts and washers.
Manufacturer-listed fitment & checks
Vehicle fitment
As listed by Dark Star Offroad
- Mercedes Sprinter Cargo, Crew or Passenger vans.
- 144 and 170 Sprinters 2007+.
Drilling required
The installation guide requires drilling upper mounting holes in the undercarriage and inner rocker panel, plus lower holes through the pinch seam.
Plus-nut tool not included
Installing the supplied plus nuts requires a plus-nut installation tool, which the guide states is not included.
Specs, parts & installation
Step construction
| Material | Aluminum |
|---|---|
| Finish | Black powder coat |
Mounting hardware
| Bolts & washers | Stainless steel |
|---|---|
| Plus nuts | Zinc-coated steel / yellow zinc |
| Nylock nuts | Zinc |
What’s in the box
Step platforms
One driver-side step platform and one passenger-side step platform.
Five mounting brackets
One driver front bracket, one driver rear bracket, one passenger front bracket and two passenger rear brackets.
Installation hardware
All required mounting hardware; the guide lists 12 plus nuts (10 required + 2 extra), 20 button head bolts, 10 flat head bolts, 20 Nylock nuts and 30 washers.
Installation at a glance
Dark Star Offroad’s guide estimates 4 HRS and recommends an additional person to hold the step.
A floor jack can be used instead of a helper to hoist the step assemblies.
The guide recommends rust-prevention coating on drilled holes and blue Loctite or similar thread locker on bracket bolts.
Installation sequence in the maker guide
- Assemble each step with its brackets and use the assembly as the template for mounting-hole positions.
- Keep the lower brackets flush with the outer wall of the rocker panel while positioning the driver-side assembly.
- Mark the upper holes, lower the assembly, drill the holes and install the supplied plus nuts.
- Do not overtighten the plus nuts: the guide warns that a spinning plus nut must be drilled out and replaced.
- Raise the assembly again and attach it to the installed plus nuts; use the brackets to locate the lower holes.
- When drilling through the pinch seam, take care not to drill into the step.
- Install the lower mounting hardware and complete the passenger-side assembly using the guide’s side-specific instructions.
Lead Time
Read Dark Star Offroad lead time policy on WNDR BuiltWarranty
Read Dark Star Offroad warranty policy on WNDR BuiltReturns
New, unused parts qualify for full refunds after inspection; installed parts are nonreturnable, and return shipping is not covered.
Read Dark Star Offroad returns policy on WNDR BuiltWhat are people saying?
Find owner feedback, discussions, and installation videos for this product.
Searches use the manufacturer and product name and open in a new tab. Results may include similar products.
WNDR Built Community
Our community blog is coming in the future.
Community · Coming soon